Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Warning

For upgrading dongle licences, please see: Updating your USB Dongle

 

Hardware Licence Dongles

The USB hardware licence dongle (as shown in Figure 31below) is a small hardware device that plugs into a USB port on a host computer to provide licence information to our software.

 

Image Removed     Image Added

Figure 1

 

Our dongles are based on an advanced microprocessor smart chip which has been certified by EAL4+ and ITSEC.

...

The dongles register with the operating system as an HID (Human Interface Device).  The generic HID drivers will be installed when the dongle is first inserted.   As they require no external device driver during installation, this minimises the common technical issues which surround the use of hardware licences.  Once the HID device driver has been registered, simply inserting the USB dongle into a spare USB port prior to launching the application will allow the software to launch in a registered state.

 

Image Added

 

Tip
titleTip

You may have issues with the dongle being detected if you use a non-powered USB hub.  In this situation, the USB device may not get the required voltage to operate correctly.  Either use a powered USB hub or ensure you plug the dongle into a socket connected directly to the motherboard.  Please wait until the dongle LED stops flashing before you run any of our software otherwise the dongle may not be detected.

...

The software can also update the Dongle with a valid Dongle Update File (*.DDUpd).  The Dongle Update file will be emailed to you as and when required (e.g. when additional modules or products are purchased). 

 

Image RemovedImage Added

Figure 2

Once you have installed the software, please follow the instructions below to update the dongle.  When updating the USB dongle, it is extremely important that the dongle is not removed from your system (or the system powered down) as this could result in the hardware being damaged. 

...

Click on ‘Update Dongle’ and select the corresponding Update File (as shown in Figure 333).  In this example, we are updating a dongle with the ID: 0xFA85FB4C.

 

Image Added

Figure 3

When you select the appropriate update file, you will see a warning message (Figure 344) asking you if you wish to continue and update the Dongle.  Click ‘Yes’ if you wish to apply the update to your dongle.

 

Image Added

Figure 4

The Licence Manager will then update the licence information on the dongle and will display a message to show this has been successfully completed.  The update process should take no longer than 5 seconds.  Once the message has been displayed to inform you the update was successful, the Licence Manager will reload the dongle and display the new licence information.

...